logo
Thread Tools
This thread is privately moderated by flyright40, who may elect to delete unwanted replies.
Old 06-26-2020, 07:09 PM
flyright40 is offline
Find More Posts by flyright40
Trader Rating: 3
Registered User
United States, NC, Wilmington
Joined Oct 2012
5 Posts
Trader Rating: 3
Wanted
Dle111

Got one with a tillonson carb with chock on one side and throttle on the other would anyone know what the needle setting would be I got it to run just a lot of smutt low end is 1/2 trun out and high is about 1 1/2 out and I know that's not right or I mite just put a walbro on it and be done thanks guys
flyright40 is offline Find More Posts by flyright40
Reply With Quote Quick reply to this message
Sign up now
to remove ads between posts
Old 06-26-2020, 09:45 PM
505Jeepster is offline
Find More Posts by 505Jeepster
Trader Rating: 3
Registered User
United States, NM, Aztec
Joined Sep 2018
2 Posts
Trader Rating: 3
Tillison should not be too much different than walbro. Try setting at 1 1/2 turns on top and bottom end to start with. It will be rich there. Adjust in from there starting with the bottom to get a nice crackling idle. Then adjust top end to get a clean mid to high end. Recheck the idle and fly it. Should end up around 1 1/4 to 1 1/8 on either one depending on altitude.
Hope that helps.
505Jeepster is offline Find More Posts by 505Jeepster
Reply With Quote Quick reply to this message
Old 06-27-2020, 07:04 AM
flyright40 is offline
Find More Posts by flyright40
Trader Rating: 3
Registered User
United States, NC, Wilmington
Joined Oct 2012
5 Posts
Trader Rating: 3
Thanks will try later this afternoon
flyright40 is offline Find More Posts by flyright40
Reply With Quote Quick reply to this message


Quick Reply
Message:

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools