|
|
|
Ignition cut off on dual receivers
I'm setting up my Edge with dual receivers, and installing my Smart Fly cutoff. I've long since lost the instructions, so please tell me if I'm doing this right. I'm thinking that I plug it into the same channel on both receivers, that way I can kill the engine from either one. The question I have is, if I switch one receiver off and back on, the green light on it flashes until I turn off both receivers. Same happens if I don't switch both receivers on at the same time.
Is this how it's supposed to behave? |
|
|
|
|
Re: Ignition cut off on dual receivers
The how-to's are here:
http://www.rcuniverse.com/magazine/a...article_id=375 |
|
|
|
Re: Ignition cut off on dual receivers
what I did with the EDC optical cutoff is the throttle is on Ch 3 on one RX and the cuttoff is on an AUX channel on the other RX....
then I mixed them together so when I hit my engine cutoff switch it is doint the normal "close the throttle barrel" shut off AND the optical cutoff at the same time |
|
||
|
Re: Ignition cut off on dual receivers
Quote:
Smart Fly Ignition Cutoff 1.PDF |
|
|
|
Phoenix, AZ
Joined Sep 2006
447 Posts
|
Re: Ignition cut off on dual receivers
Hi Nick,
The reason the LED blinks is an indication that it saw two receivers but now only sees one. This is just information for you in case you are trying to check the system operation. I have attached the user manual for the Ignition Cutoff. Please let me know if you have any other questions. |
|
|
|
Re: Ignition cut off on dual receivers
What I'm referring to is if I turn one receiver off, it blinks, but then even after turning it back on it still blinks. Is that normal? I'm guessing that it is, it's just telling me that at some point I had a receiver go offline.
|
|
|
Phoenix, AZ
Joined Sep 2006
447 Posts
|
Re: Ignition cut off on dual receivers
Hi Nick,
You are correct in your assumption. It will always blink after loosing a receiver in a two receiver setup, even when the other one comes back on. This way you know if you lost a receiver at some point. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Similar Threads | |||||
Category | Thread | Thread Starter | Forum | Replies | Last Post |
Running dual JR receivers! | DC Gayhart | General Discussion | 15 | 07-27-2011 02:04 PM | |
Dual Receiver's on 2.4 GHz | Dean Allison | Australia | 20 | 04-02-2007 11:39 PM | |
Dual receivers | rmothers | Radios | 22 | 03-14-2007 10:43 AM |