bob,
I'm currently using the eq6 turbo on my aeroworks 260 100cc. I have two 8611a servos on each aileron (channel 2 and 6). Following your directions, the system allows me to set the mid point and end points for the servos on channel 2 however when I go thru the same sequence for the servos located on channel 6, I'm only able to set the mid points. The system lights on ch6 blink fast but when I push the aileron transmitter stick all the way over and hold it there, it will not go into the end point function. Like I said, everything worked adjusting the servos on ch 2.

any help would be greatly appreciated.

mickey (fellow EVA flyer)

Hi, are you sure you set the endpoint hold on channel 6? You must set endpoint hold on each channel you wish it to work on. On channel 6, do the servos move to the endpoints when you move the stick? If you want to call we can walk though this.