ahh!! Thanks for the reply, no problem for the delay, I only didn't know if the email was working.

Here's a video I found of a Sypher getting put through the ringer... https://www.flyinggiants.com/gallery...o=4052&cat=508

This video is of the first Sypher made and is much smaller than the one that I sell now. There has been a few changes to thew one in the video. I will post a link to a video of the one he flys now.

Can't get the link to post

so what do people paint ther sypher's with to make it look like it carbon fiber? i thinks it looks cool.

First lay down all black paint and then use the rubber shelf paper stuff they sell at wall-mart as a mask and spray silver or pearlized silver paint. Mark is one hell of a painter. Oh ya and pilot

Here is that link...
www.insanefoamies.com/forsale/BAMarkSypher.wmv

sweet video thanx!

also does anyone have any links to where i can buy the templates to paint a foamy in a carbon fiber scheme?

Home Depot.com It is anti slip padding for tool box drawers and keeping boards from sliding around while routing. Just look in the tool section. You can get a sizable roll for 5 bucks. One trick once you paint it sliver you can not tell what kind of coverage you have done. So every time you do a new section paint the mat black again so you can see where you have sprayed silver. It is much easier than you think. Just practice on a peice of cardboard.
Jason

we got ours from wall-mart, It is the stuff that is the hard rubber not the soft

thanx!

also another question is, a Hacker a20-34s with a tanic taps 3 cell 540mAh would be a good selection for 3D? What servos?

That motor will work, That is what Mark flys on his plane half the time but you will be pushing the batts. so make sure you keep your bursts shorter and spread apart! New cells are coming! I know TP has a higher C cell coming and I may also be carrying these new Vampower packs. They are very nice!!! Same cell as (ya you know who) and they are close to 25% CHEAPER.

what paint is foam friendly? That beavis flying vid, what was the setup on the plane? If you dont mind me asking? I need a new foamy and this looks like "the one".

here are sone pictures from the etoc. ryan