It works and works well as this is how I remove parts when swapping out engines or changing anything wood related. I also use a 1" putty knife with the heat blowing down the length of the metal and slide it between the parts.

Yep . . . last week I received my Challenger also . . . .

GP-123 also just received through mail

Savox servo's

MTW- Exhaust manifold and Alu pipes

Jeti Rex12 Assist (thinking to combine with CentralBox200)

Emcotec DPSI dual Lipo Switch

Prop 2-blade or 3-blade. Not yet ordered, looking for advice

Will start assembling just after I finished the Pilot-RC Laser 73" with DA-50

Looking sweet! & Nice color scheme. Looks sharp!

that scheme is one of my favs

Finished another 87" 40% with a Custom Art Scholl Scheme I had the Pilot group do.

Nice!


How did you get it? I’ve been trying to custom order a replacement airframe for my crashed 73 since September, but Chief kept telling me the containers where backed up so no orders… and then the rep I had been working with just stopped responding to messages

Edit: This prompted me to call the main line again. From the operators reaction it sounds like the rep I had worked with in the fall may have quit. they are working on an order for me again

Originally Posted by cbcalhoun

Finished another 87" 40% with a Custom Art Scholl Scheme I had the Pilot group do.

Always liked that scheme and they did a nice job on replicating it. Where are you getting your graphics for it from?