logo
Thread Tools
Old 05-27-2019, 09:28 PM
cotman007 is offline
Find More Posts by cotman007
Registered User
United States, FL, Summerfield
Joined Dec 2011
184 Posts
Discussion
DX8G2 question

Setting up my throttle on a new plane. When I check the monitor screen the throttle stick movers from the idle position to full throttle. But when I check the throttle movement on the plane, it doesn't move until I'm at half stick on the transmitter. I'm sure it's just a setting but I'll be damned if I can figure it out.
cotman007 is offline Find More Posts by cotman007
Reply With Quote Quick reply to this message
Sign up now
to remove ads between posts
Old 05-31-2019, 02:54 AM
DGrant is offline
Find More Posts by DGrant
Just havin' fun!
DGrant's Avatar
United States, CA, Clovis
Joined Apr 2006
417 Posts
How about if you plug the throttle into another channel? I'm almost wanting to say you need to use that calibration function on your tranny, but since the monitor shows a full movement, I would wonder what's hindering that servo.

If plugging that servo into another slot doesn't help, do a calibration on it, as that can never hurt, and usually helps get everything centered stick wise again.
DGrant is offline Find More Posts by DGrant
Reply With Quote Quick reply to this message
Old 05-31-2019, 04:43 AM
Harold Smith is offline
Find More Posts by Harold Smith
Registered User
Harold Smith's Avatar
United States, TX, Chandler
Joined Dec 2009
579 Posts
Might want to check the throttle curve setup.--Smitty
Harold Smith is offline Find More Posts by Harold Smith
Reply With Quote Quick reply to this message
Old 05-31-2019, 06:09 AM
BarracudaHockey is offline
Find More Posts by BarracudaHockey
Multi Platform Pilot
BarracudaHockey's Avatar
United States, FL, Jacksonville
Joined Dec 2007
9,586 Posts
Throttle curve issue would show up on the monitor screen
BarracudaHockey is offline Find More Posts by BarracudaHockey
Reply With Quote Quick reply to this message


Quick Reply
Message:


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools