logo
Thread Tools
This thread is privately moderated by nzflyer21, who may elect to delete unwanted replies.
Old 07-11-2019, 09:02 PM
nzflyer21 is offline
Find More Posts by nzflyer21
nzflyer21
nzflyer21's Avatar
Joined Jun 2019
16 Posts
Discussion
Back in the garage for a small session

Hello there again
Well I have managed to get out to the garage for a couple of hours today I took a small fan heater as a comrade to in an attempt to keep me warm. Didn't work, it was still cold.
So I will put up a few pictures of my efforts. I wanted to show you the small saw bench I purchased from AliExpress this year. It has really improved my cuts and keep the cross cut square in both ways. Across and downwards.

I also purchased a very small engineer s square which is proving very handy in my effort to maintain a good finish to my work. The little saw bench can easy handle up to 1\2 inch balsa wood with ease and if you go quietly it will rip the 1\2 inch as well. It can manage thin ply ok but does not like 1\4 inch at all.
I started the tail plane and elevator in this session and set out where my Robart hinges are to go . I drilled the holes and made small notches to get a closer fit.
I think this has worked out good doing this part early in the build.
nzflyer21 is offline Find More Posts by nzflyer21
Reply With Quote Quick reply to this message
Sign up now
to remove ads between posts


Quick Reply
Message:

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools