Change of plans for motor/servos ect.

Going with:

Axi 2204/54
Jeti 8 Amp ESC
FMA Direct M5 Rx
GWS Pico Servos on Rudder/Elevator Pull-Pull
Eflite S75 on Ailerons
Thunder Power 2 Cell 480mah Batteries

As of now, I have motor installed, ESC installed, all 3 servos installed (minus aileron servo arm), receiver installed. Weight as of now is 6 oz flat without battery, pull-pull linkages, carbon connectors for ailerons, and control horns in surfaces.

Looking at around 7 oz for all up weight. Beginning to think it isnt that bad for 450-475 square inches of wing area.

I am also building another plane for the JR Indoor Festival as well. (Hint: See My Second Design in my blog).

Seth