logo
Thread Tools
Old 08-22-2009, 09:23 AM
flyinandy is offline
Find More Posts by flyinandy
Flyin' Around
Perth, Western Australia
Joined Aug 2009
7 Posts
Pilot RC Yak 100cc - Servo sizes?

Will be getting my Pilot RC Yak and DA100L in a few weeks and am planning all the other bits and pieces at the moment. I'm thinking of going Futaba for the servos all round - any suggetions on what sizes I ought to be going for? Particularly for the rudder?
flyinandy is offline Find More Posts by flyinandy
Reply With Quote
Sign up now
to remove ads between posts
Old 08-22-2009, 09:29 AM
torquen is offline
Find More Posts by torquen
Registered User
torquen's Avatar
Lodi, Ca. USA
Joined Jan 2006
1,367 Posts
Re: Pilot RC Yak 100cc - Servo sizes?

Flyinandy, I have the same plane and I'm using all Futaba. I'm using 9156's on the elevators and ailerons, and two of the new 9175's on the rudder. This setup is awesome! Extremely strong rudder that centers right on every time. If you go Futaba you wont be sorry
Garrett
torquen is offline Find More Posts by torquen
Reply With Quote
Old 08-22-2009, 09:33 AM
flyinandy is offline
Find More Posts by flyinandy
Flyin' Around
Perth, Western Australia
Joined Aug 2009
7 Posts
Re: Pilot RC Yak 100cc - Servo sizes?

Garret, thanks for that, thats pretty much what I had in mind, but did you mean 2 x S9157's on the rudder, or is 9175 an even later, newer servo?
flyinandy is offline Find More Posts by flyinandy
Reply With Quote



Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Pilot RC 97" Extra 260 Hacker A80-8 bsipro Build Threads - Electrics 48 04-24-2010 07:32 PM
RC Pilot 30% Yak Build mikeshobbies Pilot RC Support Forum 10 11-24-2009 01:07 PM
pilot rc Yak vs extreme Yak cyclone Airframes and Kits 43 02-28-2009 11:29 AM
50cc Yak alternate servo placement Boulder Manufacturer's Announcements 8 09-03-2006 06:15 PM
NEW Extreme Flight RC Yak 54, 74 Inch! Ian Build Threads 28 08-15-2006 01:23 PM