What’s your beef with MKS?? They make a great servo!

I’m using Promodeler servos in my 40% Yak, check them out:

http://www.promodeler.com/

Originally Posted by SMOKINMAC

I’m using Promodeler servos in my 40% Yak, check them out:

http://www.promodeler.com/

There look pretty nicely made, Should last a very long time.

Originally Posted by SMOKINMAC

I’m using Promodeler servos in my 40% Yak, check them out:

http://www.promodeler.com/

+1 on those!

Looks like we are all wasting our time guys... the OP has not chimed in one time! Lol I would still like to know why he wants a substitute for MKS.

Has Savox established US based service? I had 3 savox servos fail on me IN flight a few years ago. Called Savox just to get them rebuilt (not even asking them to replace them or anything) and was told there was no US service and I should throw them away. Yes, I was actually told to throw several hundred dollars worth of servos that just needed gears/service in the trash.


Not sure if this is still the case, but I was extremely disappointed when it happened.

Originally Posted by Brian yak dude

Has Savox established US based service? I had 3 savox servos fail on me IN flight a few years ago. Called Savox just to get them rebuilt (not even asking them to replace them or anything) and was told there was no US service and I should throw them away. Yes, I was actually told to throw several hundred dollars worth of servos that just needed gears/service in the trash.


Not sure if this is still the case, but I was extremely disappointed when it happened.

Savox USA
https://www.savoxusa.com/

Originally Posted by BarracudaHockey

Savox USA
https://www.savoxusa.com/

Good to see. Again, that was some time ago.

Savox 2290.
The best you can have.

Ive been trying out a few of these,

https://www.kstsz.com/

Heli direct uses them as private label in turbine jets. I never cared for Savox , I use and like JR, MKS, Xpert. but wanting to control costs trying out KST on 2 3D models and really happy, I even put a 20g digital 75oz metal gear 2 inches behind a .20CC to run a Walbro throttle in a 3D. So far it looks worth while time and gear slop yet to be dtermined.............

Hi!

Sorry I haven't seen this in a bit. I just finished school and I am going into Highschool as a Freshman9(finally!) so I haven't seen this in a bit. I don't have anything against MKS, there just SO EXPENSIVE!!!! Otherwise, I asked this because I am starting to get into larger planes(75"-91") and I wanted to know everyone preferences.

Thanks!

Jackson

I put these in a 20CC profile 3D plane and its performing beyond expectations, metal gear trains are smooth as my Xpert servos. However my brushless Xpert center slowly when radio turned on the KST jump as most others do. But hellova cost savings......


https://alofthobbies.com/kst-bls-815...lic-servo.html

I like Savox, JR and Xpert. Even ProModeler is doing quite well for alot of guys.

Originally Posted by FGNewbie

there are many to choose from. the new spektrum brushless with the soft start are certainly worth a look. I replaced my 8911s with 6300s. I also would not hesitate to use anything in the Savox line.

Soft start is a neat feature. Futaba has it as well.

Futaba 9177 and Futaba a700 are holding up quite well for me