logo
Thread Tools
Old 12-22-2019, 03:05 AM
Motomazzo is online now
Find More Posts by Motomazzo
Registered User
Joined Nov 2019
58 Posts
Very cool, Craig. Thanks for the pics. I just inherited a NIB Brison 3.2. I told Richard I’m going to have him kit me a Super Rookie after I finish this Ultimate. I think those two would be perfect for each other.
Motomazzo is online now Find More Posts by Motomazzo
Reply With Quote Quick reply to this message
Sign up now
to remove ads between posts
Old 12-22-2019, 09:44 AM
Motomazzo is online now
Find More Posts by Motomazzo
Registered User
Joined Nov 2019
58 Posts
Built a poor man’s autoclave to cure out the resin on the wing center section. I’ve read comments on curing of Bob Smith Industries 20-minute “Finish-Cure” epoxy. Some have said it would never cure. In the instructions, there are explicit instructions that “THE FINISH AREA MUST REMAIN ABOVE 75 DEGREES FOR 8 HOURS FOR PROPER CURE.” I applied a strip of 4” fiberglass with it yesterday and kept heat lamps on it. It hardened just fine and was sandable in less than 8 hours. But for the larger 7.5” piece, I decided to build something to keep the heat a little more evenly distributed. Not too bad for $1.93.
Motomazzo is online now Find More Posts by Motomazzo
Reply With Quote Quick reply to this message
Old 12-26-2019, 09:01 PM
Motomazzo is online now
Find More Posts by Motomazzo
Registered User
Joined Nov 2019
58 Posts
Got the tail installed.
Motomazzo is online now Find More Posts by Motomazzo
Reply With Quote Quick reply to this message
Old 01-01-2020, 01:10 AM
Motomazzo is online now
Find More Posts by Motomazzo
Registered User
Joined Nov 2019
58 Posts
Decided on hard-point locations for the tail brace attachment points.
Motomazzo is online now Find More Posts by Motomazzo
Reply With Quote Quick reply to this message


Quick Reply
Message:


Currently Active Users Viewing This Thread: 2 (0 members and 2 guests)
 
Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion I want this wolfblitzer General Discussion 3 02-05-2014 09:08 AM
Dual DA-200s on a 250lb Plane escottcarp New Member Section 4 09-05-2009 08:00 PM