I had one for seven years that had the O.S. 1.60FX up front. Unfortunately lost it to a bad battery. Flew very well and scale like but if i had to do it again i would go with a lightweight 50cc gasser.

I have the christen Eagle...I'm running the crrc pro 40 love it

DA 50 ALL DAY LONG....................

think he might have it rigged up by now guys......thread is 2 years old

Ah found a pic..

Originally Posted by beejay

I know this is an old thread, but does anyone have photos of the engine mounts and throttle setup using a dl50 or dle55?? Bit of a long shot I know

i put one on for a friend of mine no pics but choke was manual pushrod came out right before the front scoop thrttlr was in the fuse it was a easy install.

Originally Posted by JohnBer

think he might have it rigged up by now guys......thread is 2 years old

Hence me saying: "I know this is an old thread but...."

I had a both a DA-50 then DLE-55 on mine. The Eagle was cool, but after an emergency landing in some black berry bushes I did a little recover! As for the throttle, mounted mine inside and ran golden rod to the front:

Originally Posted by beejay

I know this is an old thread, but does anyone have photos of the engine mounts and throttle setup using a dl50 or dle55?? Bit of a long shot I know

My throttle servo is where the manual suggested..my 40 is side mount carb..
used ball link...

It's more a pic of the standoffs that I need. Been told they fit good, but I can't see how you would get in behind (in the box bit) to do the standoffs up?

Originally Posted by beejay

It's more a pic of the standoffs that I need. Been told they fit good, but I can't see how you would get in behind (in the box bit) to do the standoffs up?

My crrc pro has I beam mounts...I have more pics on my other computer..
I don't think mine is what your looking for...

Originally Posted by beejay

It's more a pic of the standoffs that I need. Been told they fit good, but I can't see how you would get in behind (in the box bit) to do the standoffs up?

Lay out your bolt pat.drill them...the take a dermal cut slots above them on the top of the box us a pair forceps to hold the t nut...the bottom will be under the box...

Thanks Dennis. But *** is a t nut?

Originally Posted by beejay

Thanks Dennis. But *** is a t nut?

The bline nuts...

ah, of course. I dont have blind nuts tho, managed to work my way round it, now to work out the throttle servo...