|
|
|
Discussion
Power Box Spark
I have a power box ignition cut off. Cannot get it to work. Have power and connected to receiver good. Servo will work on the channel but not the power box. Have adjusted signal limits to 100+ and 100-. Using a Futaba 14MZ radio. any suggestions that I can try?
|
|
|
|
|
You want to have your travel at 0 to 100+ or 0 to 100- for safe mode.
|
|
|
|
Ok just adjusted my TX to the settings as above. No change. I have checked all the inputs and they are as should be. Power in from battery and receiver at 6 volts. Output to ignition is zero. Im starting to think the PB has gone dead.
|
|
||
|
Quote:
The "output to ignition" was the question in my mind... since you apparently checked that, you answered my question before I even asked... ... reason for my question is, the LED's on these types of devices can and do burn out occasionally, and the ignitions still work fine, only your LED indicator won't tell you when it's armed. ... but since you've checked the actual output from the device... hmm.... I got nothin'.... other then try another channel, or try another ign device (or anything else) in that channel. TechAero always comes to mind. I'm hooked on those. Good luck with it. |
|
|
|
|
My guess is the radio configuration is wrong but without the radio and plane in my hand its hard to tell.
Make sure the switch is in normal mode and that you're going from center of the channels throw to the full throw in the proper direction. Not sure what the Futaba numbers equate to. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |