Originally Posted by Duosport

Rich B, I have the same plane but in "superlight" measurement could be different. You could continue on with your build. Very late in the instructions you will be asked to add servo carbon fiber push rods and the small wood rod supports. The slot for control horn cut in your rudder will be in a straight line with the small wood rod supports that run down the fuselage. On my "superlight" instructions there is a good photograph rod alignment and control horn. If your instructions show a similar photo it will be helpful.

Thank you I will keep that in mind if I do not get the measurements. I also sent out an email to TH. If I do have to go with your recommendations, which I appreciate, is the control horn eyelit centered of the hinge gap or offset one way or the other?

Rich B, my control horn eye is about 1/16" forward of hinge center. Hope to see ya flying Sunday night. You should be ez to pick out. At this point of the indoor season our planes are well beat. Yours will be mint fresh.

Thanks. lol, yeah both times I have gone carnage was present. The club sure has a fun time there. I really enjoy it.

I corresponded with TH; Brad advised it is four inches up from the bottom. Love the customer service. Thank you!

This is my lite version. It is 4" from the bottom. Look harder for the precut slot they close up and are hard to see some times. the eye should be right on the hinge line

Hey thanks a lot Randy! As they say a picture is worth a thousand words. I even held the rudder up to a very bright light... Nothing. I sent pictures to TH. Brad appreciated me sending them to verify what happened or should I said what didn't lol. He said that was a first they had seen and is forwarding on to the manufacture. No big deal really, its all good. The plane is nice.

Ooh a new plane, everyone sharpen your props for Sunday night!

Originally Posted by Clever1

Ooh a new plane, everyone sharpen your props for Sunday night!

Lol yeah I know I am in for it with you guys. I think I will do plenty to it on my own... He, heh!

Bring some welders rich.

I will... Bringing my crash tool box lol.

Originally Posted by Rich_B

I will... Bringing my crash tool box lol.

Is it ready to fly?

Yes

Sold the extra..Bring on the edge. 92" comming soon.

Great news!
Did you get one before they went out of stock?