logo
Thread Tools
Old 01-07-2006, 01:11 AM
Rob B is offline
Find More Posts by Rob B
The Huckster
Rob B's Avatar
Joined Jan 2006
197 Posts
Header question

Does anyone know what is being used to hold the flex pipe onto the straight pipe in this picture?
Rob B is offline Find More Posts by Rob B
Reply With Quote Quick reply to this message
Sign up now
to remove ads between posts
Old 01-07-2006, 01:27 AM
rcdart is offline
Find More Posts by rcdart
Would be, if I could be
rcdart's Avatar
QLD Australia
Joined Jan 2006
4,180 Posts
Re: Header question

I think you will find that it is silver soldered
rcdart is offline Find More Posts by rcdart
Reply With Quote Quick reply to this message
Old 01-07-2006, 01:32 AM
Rob B is offline
Find More Posts by Rob B
The Huckster
Rob B's Avatar
Joined Jan 2006
197 Posts
Re: Header question

Thanks rc dart.... i'm new to the big stuff, so i'm trying to figure it all out. Thanks again
Rob B is offline Find More Posts by Rob B
Reply With Quote Quick reply to this message
Old 01-07-2006, 11:44 PM
Neogenesis is offline
Find More Posts by Neogenesis
Down Low..Too Slow..DOH!!
Neogenesis's Avatar
Findlay, OH
Joined Jan 2006
1,206 Posts
Re: Header question

Now I'm not real fmailiar with melting points, but is does silver solder have a high enough melting point to not melt under operation?



Neo Out!!!!
Neogenesis is offline Find More Posts by Neogenesis
Reply With Quote Quick reply to this message


Quick Reply
Message:


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Krill 28% Katana - need header and canister suggestion tommy321 Airframes and Kits 7 01-13-2009 05:26 AM
Another header question? airbusmech Desert Aircraft Support 5 01-17-2008 02:41 PM
Header and canister Question BuzzardChaser Gas Engines 11 06-13-2007 03:24 PM
Header length matching trick shannah Gas Engines 0 12-23-2006 11:05 PM
HEADER COULPER Dennis C Gas Engines 10 08-15-2006 07:12 PM