logo
Thread Tools
Old 09-18-2019, 05:44 PM
jamesrxx951 is offline
Find More Posts by jamesrxx951
Registered User
jamesrxx951's Avatar
toledo ohio
Joined Jan 2009
10,443 Posts
Discussion
JR XG11 landing gear and door sequence

I am trying to figure out a way to program landing gear and door sequencer on my XG11. I can control the servo with a switch but the issue is timing. Does anyone have experience with scale programming for landing gears and doors?
jamesrxx951 is offline Find More Posts by jamesrxx951
Reply With Quote Quick reply to this message
Sign up now
to remove ads between posts
Old 09-18-2019, 06:32 PM
lrb75 is offline
Find More Posts by lrb75
Registered User
United States, VA, Springfield
Joined Aug 2010
44 Posts
Get an on board sequencer. I have had an 11x for many years. Not aware of anyway to sequence movements. Delay wont get it done. Rcbee made a nice one but they appear to be out of business.
lrb75 is offline Find More Posts by lrb75
Reply With Quote Quick reply to this message
Old 09-18-2019, 10:21 PM
Bill Vargas is offline
Find More Posts by Bill Vargas
3W/ZDZ Flyer
Bill Vargas's Avatar
United States, CA, Apple Valley
Joined Mar 2011
3,179 Posts
Dreamworks,,, https://www.dreamworksrc.com/air-sys...equencers.html


BV
Bill Vargas is offline Find More Posts by Bill Vargas
Reply With Quote Quick reply to this message
Old 09-18-2019, 11:34 PM
AWorrest is offline
Find More Posts by AWorrest
Registered User
United States, NE, Lincoln
Joined Nov 2008
460 Posts
This question was asked sometime back. If the sequence is simply open doors/extend gear and retract gear/close doors, the job can easily be done using non-proportion servos for the doors and gear along with the transmitter servo speed menu. If you need open doors/extend gear/close doors and open doors/retract gear/close doors sequences, a better solution is to purchase a sequencer that can the job.

Allan
AWorrest is offline Find More Posts by AWorrest
Reply With Quote Quick reply to this message


Quick Reply
Message:


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools