![]() |
|
|
Discussion
eq10 port inop
Had two wing servos went bad on my 42% yak while practicing IMAC. One servo is almost locked up and other burned but now my port 2 is dead on eq10. I can move right ailerons over to port 9, but my question, is the eq10 repairable, and can I trust it?
|
|
![]() |
|
Phoenix, AZ
Joined Sep 2006
435 Posts
|
Hi,
I am not sure if this would be repairable. I would have to look at it but if its the IC that dries the signal output then no. This IC has gone out of manufacturing. Its really hard to say about reliability. In general I would say it should be OK but damaging the output drivers on an IC could cause other issues. I wish I could give you a definite yes or no on this. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |