logo
Thread Tools
This thread is privately moderated by 3D-Seth, who may elect to delete unwanted replies.
Old 10-27-2007, 07:40 PM
3D-Seth is offline
Find More Posts by 3D-Seth
Registered User
3D-Seth's Avatar
United States, FL, North Port
Joined Jan 2006
3,405 Posts
My First Design - Updates 3

Change of plans for motor/servos ect.

Going with:

Axi 2204/54
Jeti 8 Amp ESC
FMA Direct M5 Rx
GWS Pico Servos on Rudder/Elevator Pull-Pull
Eflite S75 on Ailerons
Thunder Power 2 Cell 480mah Batteries

As of now, I have motor installed, ESC installed, all 3 servos installed (minus aileron servo arm), receiver installed. Weight as of now is 6 oz flat without battery, pull-pull linkages, carbon connectors for ailerons, and control horns in surfaces.

Looking at around 7 oz for all up weight. Beginning to think it isnt that bad for 450-475 square inches of wing area.

I am also building another plane for the JR Indoor Festival as well. (Hint: See My Second Design in my blog).

Seth
3D-Seth is offline Find More Posts by 3D-Seth
Reply With Quote Quick reply to this message
Sign up now
to remove ads between posts


Quick Reply
Message:

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Composite 2.3 help Derek Hunter Airframes and Kits 4 02-18-2006 12:34 PM